- [Instructor] The following video displays the mounting instructions for the Coreless JRT Twin Tissue Dispenser. Always wear appropriate protective gear and follow all safety regulations and procedures. See product insert for additional information and warnings. First, determine at what height the dispenser will be hung. KC recommends at least 30 inches from the floor to the bottom of the dispenser, and 12 inches from the front edge of the toilet to the center of the dispenser. The mounting bracket should be installed seven inches higher than the desired location for the dispenser bottom end. Use the enclosed mounting bracket as a template to determine where the screw holes will be. Mark the wall accordingly. Drill the holes and insert the wall anchors, if required, then screw the mounting bracket onto the wall. Align the dispenser over the bracket, lining up the anchor slots on the back of the dispenser to the angled edges on the bracket. Push down firmly to hold in place. While the dispenser is hanging on the wall, slide the access door to the center of the dispenser to expose the bottom mounting holes. Choose either the inner or the outer set of mounting holes based on existing holes, if any, and mark the wall. Remove the dispenser and drill the wall for the remaining two wall anchors. Reattach the dispenser to the mounting brackets and secure it to the wall. Be sure to use two screws at a minimum in the lower mounting holes. You are now ready to load the tissue rolls.