Instructor: The following video
displays the loading instructions
for the Coreless JRT Tissue Dispenser.
Always wear appropriate protective gear
and follow all safety regulations and procedures.
See product insert for additional information and warnings.
Install a new roll by aligning dimple
in the center of the tissue with the left arrow
on the lower-left corner of the dispenser front.
Push the roll upward until it locks in place.
Make sure the tissue unwinds in a clockwise direction.
When a roll is installed properly,
there is one inch of tissue exposed.
When the tissue is no longer visible through the window,
the roll can be transferred to the stub roll holder.
To remove the partial roll,
push it up until the roll is free of the holder.
The roll can now be removed on either the right
or left side of the holder.
Flip the partial roll around
so that the paper unrolls in a counter-clockwise direction
and install it in the right position.
Install a new roll in the left position
so that the paper unrolls in a clockwise direction.
Push it up firmly until the roll
locks securely in the roll holder.
Provide a tail from the stub roll.
In the unlikely event it is necessary to remove a full roll,
use your fingers to depress
the metal roll holder spring behind the roll,
while gently pulling down on the roll with a rocking motion.
Do not force the roll out by pulling straight down
or damage will occur to your dispenser.