- [Narrator] In this video, you will learn how to install the Mod High Capacity Single Roll Bath Tissue Dispenser. Always wear appropriate protective gear and follow all safety regulations and procedures. To install the dispenser you will need the four screws and wall anchors provided, a tape measure, level, screwdriver, pencil 1/4 inch drill bit, a drill and a hammer. Open the front cover using the key. If you wish to install a keyless entry, remove one of the two push buttons on the back of the dispenser housing. Remove the key plug on the top of the cover and press the button into the hole until it clicks in place. Close and open the cover to ensure the pushbutton is functioning properly. Using the back of the dispenser as a template, hold the dispenser seven to eight inches from the edge of the toilet, and 40 inches from the base of the housing to the floor. To ensure the dispenser is straight, place a level on the housing and then mark the holes. Punch or drill the marked holes and insert the wall anchors. Align the dispenser with the wall anchors, and fasten to the wall surface using the screws provided. Insert the two eight-shaped roll holders into the tracks on the housing and close the cover to ensure proper alignment. You are now ready to load bathroom tissue. In this portion of the video, you will learn how to load the bathroom tissue into the dispenser. With the door open, remove the roll holders. Load the bathroom tissue on the roll holder with the paper dispensing over the roll, noting how the nub of the roll holder fits into the dimple on the roll, repeat the process with the other roll holder. Place the loaded roll holders back into the tracks, noting that there is no left or right specific track. Close the dispenser door firmly and begin dispensing. When the bottom roll is fully used, follow the label directions on the bottom of the cover. Using the center bar, push up and back to advance the next full roll of bathroom tissue from above.