- [Instructor] The following video displays the mounting instructions for the JRT Combination Tissue Dispenser. Always wear appropriate protective gear and follow all safety regulations and procedures. See product insert for additional information and warnings. First, determine at what height the dispenser will be hung. KC recommends that the bottom edge of the dispenser be at least 30 inches from the floor, and 12 inches from the front edge of the toilet to the center of the dispenser. Place the dispenser on the wall at the desired height to determine where the screw holes will be and mark the wall accordingly. Drill the holes and insert wall anchors, if required for that wall type. Determine which size jumbo roll tissue product will be used with this dispenser. The dispenser comes preset from the factory for two nine-inch jumbo tissue rolls. If it's for use with 12-inch tissue rolls, move the hubs by depressing the hub locking pin. Rotate one hub to the 12-inch position until it clicks and locks. Rotate the other hub to the stub roll position until it clicks and lock. It is recommended that the 12-inch roll be located farthest away from the user when the dispenser is installed. Please note, prior to mounting, ensure the roll holders are positioned for the product that will be used. Align the dispenser over the mounting holes and attach it with a minimum of five screws. Once the dispenser is installed, the hub positions can only be changed by loosening the mounting screws and pulling the unit approximately one quarter of an inch from the wall, so that the hub locking pins can be depressed in. There are two locking options for the cover. You can either use the included metal key, or the push button lock, which is molded onto the back wall of the dispenser. To install the push button lock feature, first, open the cover, depress the end of the lock spring, and remove the decorative plug by pushing on the tabs of the plug. Be sure not to overstress or bend the spring. Slide the push button under the lock spring and insert the button through the hole in the cover. Release the lock spring back to its original position. The window-style dispenser will accommodate a decorative strip. To install, insert the strip into the tabs of the inside of the window and slide it into place. You are now ready to load the jumbo tissue rolls.