Instructor: In this video, you will learn
how to mount the Scott MOD Slimroll Towel Dispenser System.
Always wear appropriate protective gear
and follow all safety regulations and procedures.
To install the dispenser,
you will need the four screws and wall anchors provided,
a tape measure, screwdriver, pencil, 1/4 inch drill bit,
a drill and a hammer.
Kimberly-Clark Professional recommends
the bottom of the dispenser,
should measure 48 inches from the floor.
Use the enclosed template to mark the holes for drilling.
Drill the holes using the 1/4 inch drill bit.
(drill buzzing)
Insert the wall anchors into the holes.
Align the dispenser over the anchors
and drive the screws into the wall.
Use a minimum of four screws.
Now you are ready to load the towel roll.